Interface Board for CCT-100 cable tester.
- Align the three holes of the board with the three mounting pegs on the tester
- Then, push the connector in place and snap the pegs into the holes.
- After assembly install a known good cable and verify that the unique code is correct.
- Snap the board over the mounting holes
- Pull the board away from the connector
- 3″x 2″ small footprint
- All RoHS compiant
- Attaches to CCT-100 without additional hardware
- Has On-board fifteen pin female D-Sub Connector
- Has On-board nine pin female D-Sub Connector
- Allows for single handed operation
- Can be installed or uninstalled in less than 15 seconds